Translations:KAVAN SLING Mini 616mm - Instruction manual/32/en: Difference between revisions
(Importing a new version from external source) |
(Importing a new version from external source) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
==== Please Remember ==== | ==== Please Remember ==== | ||
* Always turn the transmitter on first. Only then plug the receiver (Rx) battery to the model. | |||
* At the end of your flying session, unplug the Rx battery from the model. Turn the transmitter off last. | |||
* You MUST use the included LiPo Charger built in the transmitter ONLY. Failure to do so may result in a fire causing personal injury and/or property damage. | |||
* If at any time during the charge process the battery begins to inflate, discontinue charging immediately. Quickly and safely disconnect the battery, then place it in a safe, open area away from flammable materials to observe it for 30–45 minutes. Continuing to charge or discharge a battery that has begun to balloon or swell can result in a fire. A battery that has inflated even a small amount must be removed from service completely. | |||
* You must charge the included 3.7V 170 mAh LiPo battery in a safe area away from flammable materials. | |||
* Never charge the battery unattended. When charging the battery, you should always remain in constant observation to monitor the charging process and react to potential problems that may occur. | |||
* Store the battery at room temperature in a dry area for best results. | |||
* When transporting or temporarily storing the battery, the temperature range should be from 20–30°C. Do not store the battery or model in a car or direct sunlight whenever possible. If stored in a hot car, the battery can be damaged or even catch fire. | |||
* Do not over-discharge the LiPo flight battery. Discharging the battery too low can cause damage to the battery, resulting in explosion and/or fire. | |||
* LiPo cells should not be discharged to below 3 V under load. | |||
Latest revision as of 09:55, 16 October 2025
Please Remember
- Always turn the transmitter on first. Only then plug the receiver (Rx) battery to the model.
- At the end of your flying session, unplug the Rx battery from the model. Turn the transmitter off last.
- You MUST use the included LiPo Charger built in the transmitter ONLY. Failure to do so may result in a fire causing personal injury and/or property damage.
- If at any time during the charge process the battery begins to inflate, discontinue charging immediately. Quickly and safely disconnect the battery, then place it in a safe, open area away from flammable materials to observe it for 30–45 minutes. Continuing to charge or discharge a battery that has begun to balloon or swell can result in a fire. A battery that has inflated even a small amount must be removed from service completely.
- You must charge the included 3.7V 170 mAh LiPo battery in a safe area away from flammable materials.
- Never charge the battery unattended. When charging the battery, you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
- Store the battery at room temperature in a dry area for best results.
- When transporting or temporarily storing the battery, the temperature range should be from 20–30°C. Do not store the battery or model in a car or direct sunlight whenever possible. If stored in a hot car, the battery can be damaged or even catch fire.
- Do not over-discharge the LiPo flight battery. Discharging the battery too low can cause damage to the battery, resulting in explosion and/or fire.
- LiPo cells should not be discharged to below 3 V under load.