Translations:KAVAN Strike DLG 1498mm - Instruction manual/17/en: Difference between revisions

From KAVAN RC Wiki
(Importing a new version from external source)
 
 
(No difference)

Latest revision as of 13:28, 11 December 2024

Message definition (KAVAN Strike DLG 1498mm - Instruction manual)
'''Wing'''
* Thoroughly epoxy the carbon discus-launch pin into the left (for a right-handed pilot) or right (for a left-handed pilot) wing tip. '''(Fig. 33)'''
* Remove the covering film over the openings for the aileron servo arms in the '''W52''' top cover plates and in the W53 bottom cover plate. Install aileron servos with arms fitted (set them to neutral with your radio on), aileron horns and linkage the same way you did with the rudder and elevator. Finally, using a piece of sticky or iron-on film seal the opening in the '''W53''' bottom cover plates. '''(Fig. 34+35)'''

Wing

  • Thoroughly epoxy the carbon discus-launch pin into the left (for a right-handed pilot) or right (for a left-handed pilot) wing tip. (Fig. 33)
  • Remove the covering film over the openings for the aileron servo arms in the W52 top cover plates and in the W53 bottom cover plate. Install aileron servos with arms fitted (set them to neutral with your radio on), aileron horns and linkage the same way you did with the rudder and elevator. Finally, using a piece of sticky or iron-on film seal the opening in the W53 bottom cover plates. (Fig. 34+35)