Translations:KAVAN FT160AR - Instruction Manual/123/cs: Difference between revisions

Revision as of 11:26, 15 October 2025

Message definition (KAVAN FT160AR - Instruction Manual)

If the gap is found to be too small or too large, reset the valve clearance as follows:
# Carefully loose the locknut on one rocker arm with wrench.
# Turn adjusting screw approx. 1/2 turn counter clockwise to open gap.
# Insert 0.04 mm feeler gauge between valve stem and rocker arm, and gently turn adjusting screw clockwise with a screwdriver until it stops.
# Re-tighten the locknut while holding the adjusting screw with a screwdriver.
# Remove 0.04 feeler gauge, rotate prop through exactly two turns and re-check gap. If the valve clearance is correctly adjusted, check other valve and adjust if necessary. Then replace rocker cover.
# Check the other cylinder and adjust, if necessary, in the same way

Pokud zjistíte, že je mezera příliš malá nebo příliš velká, znovu nastavte vůli ventilů takto:

Revision as of 16:06, 5 August 2025 view source Mrs. Kavan (talk \| contribs) Interface administrators, Administrators, translator 19,448 edits Created page with "Pokud zjistíte, že je mezera příliš malá nebo příliš velká, znovu nastavte vůli ventilů takto:"		Revision as of 11:26, 15 October 2025 view source FuzzyBot (talk \| contribs) 14,395 edits m FuzzyBot moved page Translations:Kavan FT160AR - Instruction Manual/123/cs to Translations:KAVAN FT160AR - Instruction Manual/123/cs without leaving a redirect: Part of translatable page "Kavan FT160AR - Instruction Manual" Newer edit →
(No difference)