Translations:KAVAN SLING Mini 616mm - Instruction manual/32/en

From KAVAN RC Wiki
Revision as of 09:20, 16 October 2025 by FuzzyBot (talk | contribs) (Importing a new version from external source)

Please Remember

  • Always turn the transmitter on first. Only then plug the receiver (Rx) battery to the model.
  • At the end of your flying session, unplug the Rx battery from the model. Turn the transmitter off last.
  • You MUST use the included LiPo Charger built in the transmitter ONLY. Failure to do so may result in a fire causing personal injury and/or property damage.
  • If at any time during the charge process the battery begins to inflate, discontinue charging immediately. Quickly and safely disconnect the battery, then place it in a safe, open area away from flammable materials to observe it for 30-45 minutes. Continuing to charge or discharge a battery that has begun to balloon or swell can result in a fire. A battery that has inflated even a small amount must be removed from service completely.
  • You must charge the included 3.7V 170 mAh LiPo battery in a safe area away from flammable materials.
  • Never charge the battery unattended. When charging the battery, you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
  • Store the battery at room temperature in a dry area for best results.
  • When transporting or temporarily storing the battery, the temperature range should be from 20-30°C. Do not store the battery or model in a car or direct sunlight whenever possible. If stored in a hot car, the battery can be damaged or even catch fire.
  • Do not over-discharge the LiPo flight battery. Discharging the battery too low can cause damage to the battery, resulting in explosion and/or fire.
  • LiPo cells should not be discharged to below 3 V under load.