Translations:KAVAN GRT-10 Brushed - Instruction manual/29/cs
Základní technické údaje
| Proud vpřed (trvalý/špičkový) | 40 A / 180 A |
| Proud vzad (trvalý/špičkový) | 20 A / 90 A |
| Napájení | 2-3S LiPo, 5-9čl. NiMH/NiCd |
| Pro auta | 1:10 on-road, off-road |
| Limit motoru (2S LiPo nebo 6čl. NiMH) | Motor řady 540 nebo 550 ≥12 závitů, <30 000ot./min při 7,2 V |
| Limit motoru (3S LiPo nebo 9čl. NiMH) | Motor řady 540 nebo 550 ≥18 závitů, <20 000ot./min při 7,2 V |
| Vnitřní odpor | Vpřed: 0,002 Ohm, vzad: 0,004 Ohm |
| Stabilizátor napájení BEC | 5 V/2 A lineární |
| Spínací frekvence | 1 kHz |
| Rozměry | 46,5×34×28,5 mm |
| Hmotnost | 65 g |
První použití regulátoru
- Regulátor, motor, přijímač, servo řízení a pohonný akumulátor zapojte dle následujícího obrázku.
“+” and “-” wires of the ESC are connected to the battery pack. WARNING: The incorrect polarity will damage the ESC immediately. The control cable of the ESC (trio wires with black, red and white colour) is connected to the throttle channel of the receiver (usually CH2). The “Motor +” and “Motor –” wires are connected to ESC without any order. If the motor runs in the opposite direction, please swap these two wire connections. - Set the Transmitter
Please set the “D/R”, “EPA” and “ATL” to 100% for throttle channel (for transmitter without LCD, please turn the knobs to the maximum value), and set the “TRIM” of the throttle channel to 0 (for transmitter without LCD, please turn the TRIM knob to its neutral position). For Futaba® and similar transmitters, the direction of throttle channel shall be set to “REV”, while other radio systems shall be set to “NOR”. For the GRT-10 transmitter, set the “TH.REV” switch to the down position. The “Fail Safe” function of the radio system is strongly recommended to be activated. Please make sure that the motor can be stopped when the “Fail Safe” happens. - Throttle Range Setting (Throttle Range Calibration)
In order to make the ESC match the throttle range of different transmitters, the calibration of the ESC is necessary.
- To calibrate the ESC, please turn on the transmitter, keep the throttle stick at its neutral position.
- Connect your power pack to the ESC, turn on the ESC switch.
- Wait for 3 seconds to let the ESC execute self-test and automatic throttle calibration. When the ESC is ready to run, a long beep sound is emitted from the motor.