KAVAN Smart PRO MPSW15 Magnetic switch - Instruction manual
Introduction
Congratulations on purchasing the Smart PRO MPSW15 Magnetic switch, a high-performance digital switch of the "REMOVE BEFORE FLIGHT" type. It operates using magnetic activation – inserting the supplied magnetic activation pin into the opening disconnects the power (opens the circuit). Removing the pin switches the device on and activates the connected circuit. The powered-on state is indicated by illuminated LED indicators. This system offers a safe and reliable solution for switching receivers, ignition systems, and other onboard electronics without the need for mechanical contacts. The switch provides reliable and secure control via a magnet, supports various types of loads including inductive, and—being contactless—has no wear due to switching cycles or current flow.
Features
- LED indication of powered-on state
- Reliable and secure control via a magnet
- Eazy to use
Technical specifications
| Specification | MPSW15 |
|---|---|
| Dimensions | Ø22,5/Ø15 x 42 mm |
| Weight (inc.cables) | 16g |
| Cables | 4x 1mm2 (17AWG) |
| Connectors | Sili-connector |
| Continuous current | 15A |
| Peak current (2s) | 25A |
| Current when off | < 3uA |
| Operating temperature | |
| Switching voltage range | 5 - 17V |
| Status LED | YES |
Installation
Connect the device according to the markings on the product, where input and switched output are clearly indicated. Observe correct polarity:
Red wire = positive (+) Black wire = negative (–)
For good performance of the integrated magnetometer, it is necessary to install the device at least 20 cm away from magnetized objects and cables powering servos/motors. In addition, please keep the device orientation respecting the flight direction as shown in the picture below (note the arrow on the device).