Translations:KAVAN R6 - User manual/55/en: Difference between revisions

From KAVAN RC Wiki
VisualWikitext
(Importing a new version from external source)
 
(Importing a new version from external source)
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
'''Custom:''' the receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
'''Custom:''' The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
'''Notes:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.
{{Note|type=info|'''Note:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before the signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.}}

Latest revision as of 10:59, 7 May 2024

Message definition (KAVAN R6 - User manual)
'''Custom:''' The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
{{Note|type=info|'''Note:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before the signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.}}

Custom: The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.

Note: If fail-safe is not set, the model will always operate with the last functional state of the channels before the signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.
Retrieved from "https://wiki.kavanrc.com/w/index.php?title=Translations:KAVAN_R6_-_User_manual/55/en&oldid=11362"