KAVAN Mirai - Instruction manual

Introduction

Precautions

This RC model is not a toy. Use it with care and strictly following the instructions in this manual.

Assemble this model following strictly these instructions. DO NOT modify or alter the model. Failure to do so, the warranty will lapse automatically. Follow the instructions in order to obtain a safe and solid model at the end of the assembly.

Children under the age of 14 must operate the model under the supervision of an adult.

Assure that the model is in perfect conditions before every flight, taking care that all the equipment works correctly and that the model is undamaged in its structure.

Fly only in days with light breeze and in a safe place away from any obstacles.

Caution: This RC model you will build and fly is not a toy! Although it may seem to be light and slow in flight it is capable of serious bodily harm and property damage. It is your responsibility and yours alone - to build this model correctly, properly install RC equipment and motor and to test the model and fly in accordance with all safety standards (and common sense) as set down in Safety Codes valid in your country. If you are just starting RC modelling, consult your local hobby shop or an experienced modeller in your local RC club to find a good instructor.

You must build the model according to the instructions. Do not alter or modify the model, as doing so may result in an unsafe of unflyable model. Take time to build straight, true and strong. Use proper radio and other equipment that is in first class condition, properly install all the components and test their correct operation before first and any further flight. Fly the model only with competent help from a well experienced modeller if you are not already an experienced RC pilot.

Note: : We, as the kit manufacturer, can provide you with a top quality kit and instructions, but ultimately the quality and flyability of your finished model depends on how you build it; therefore we cannot in any way guarantee the performance of your completed model, and no representations are expressed or implied as to the performance or safety of your completed model.

Specification

Wingspan	1995 mm
Length	1210 mm
All–up weight	420 g plus
Wing section	Special RES HB
CG position	80 mm
Controls	Rudder, elevator, airbake, (motor)

Recommended RC equipment

• Rudder and elevator servo: Hitec HS-53 2×
• Spoiler servo: Hitec HS-65MG, Dymond D47
• Receiver battery: Panasonic Eneloop AAA 800mAh 4.8 V pack

Recommended glues

Unless stated otherwise, use medium cyanoacrylate (CA) glue (KAV9952 KAVAN CA Medium). D-box sheeting and wing ribs are better to be glued using a water resistant white aliphatic resin, like our KAV9960 KAVAN White Glue (alternatively, you can use this sort of glue for most of wood-to-wood joints). The highly loaded parts (wing roots, wing main spars, firewall etc.) should be glued together using 30 minute (or slower) epoxy (like KAV9967 Epoxy 30min) offering high strength and enough time for the correct positioning.

Tools and accessories

• Very sharp modeller’s knife (e.g. Excel 16001 with No. 11 blades)
• Scissors
• Electric drill with drill bits
• Wire cutter
• Long nose pliers
• Screwdrivers
• Razor saw
• Sandpaper No. 80, 100, 180, 360-400
• Needle files
• Soldering iron and solder
• Clothing pegs
• Modeller’s pins
• Epoxy mixing stick and vessel
• Masking tape, clear sticky tape
• Rubbing alcohol (for cleaning up excessive epoxy)
• Paper tissue or soft cloth (for cleaning up excessive epoxy)
• Straightedge with scale
• Square edge
• Thin clear plastic film (for protecting the building plan)
• Permanent marker
• Modeller’s sealing iron, heat gun (for covering)
• Lightweight balsa filler