Translations:KAVAN R6 - User manual/55/en: Difference between revisions

Revision as of 13:48, 6 May 2024

Message definition (KAVAN R6 - User manual)

'''Custom:''' The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
{{Note|type=info|'''Note:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before the signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.}}

Custom: The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.

Note: If fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.

Revision as of 12:51, 15 March 2024 (view source) FuzzyBot (talk \| contribs) (Importing a new version from external source)		Revision as of 13:48, 6 May 2024 (view source) FuzzyBot (talk \| contribs) (Importing a new version from external source) Newer edit →
Line 1:		Line 1:
	'''Custom:''' ~~the~~ receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.		'''Custom:''' The receiver keeps the rate values on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to "Custom". Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
	'''~~Notes~~:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.		'''Note:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If fail-safe is disabled on the RF module side, the receiver will go to the default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode as the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.