KAVAN V20 - Changer le mode

Introduction

Changer le mode de vol est simple et rapide si vous suivez la bonne procédure. Veuillez vous référer aux étapes ci-dessous pour modifier le mode de vol de votre émetteur, ou si vous souhaitez définir le retour des bâtons.

Description

1. Ressort de tension de centrage horizontal - cardan droit

1. Vis de réglage du cliquet - cardan droit

1. Vis de réglage frein/résistance - cardan droit

1. Centralisation de la serrure à ressort

1. Ressort de tension de centrage vertical - cardan droit

1. Vis de réglage à cliquet - cardan gauche

1. Vis de réglage du frein/résistance - cardan gauche

1. Ressort de tension de centrage vertical - cardan gauche

1. Trou pour la serrure à ressort de centrage

1. Ressort de tension de centrage horizontal - cardan gauche

Steps

1. Remove the battery compartment cover.
2. Unplug and remove the battery from the battery compartment.
3. Holding the handle in your hands carefully remove the rear cover. Be careful not to pull the antennas.
4. Rotate and flip the rear cover to make some space.
5. Unscrew the centring spring lock from the current throttle stick.
6. On the current throttle side tighten the vertical tension spring counterclockwise so the stick centres.
7. On the opposite side loosen the vertical tension spring clockwise.
8. Lift the centring arm a little and insert and screw in the centring spring lock on the new throttle stick side.
9. Set the feedback of both gimbals to your preference via the steps below.
10. Put the rear cover back in place.
11. Screw in the 4 screws on the rear cover.
12. Plug in and insert the transmitter battery in the battery tray.
13. Put the battery tray cover on.

Setting the gimbal feedback

1. Screws on the inner side of the strip (2, 6) set the gimbal tension.
2. Screws on the outer side of the strip (3, 7) set the ratcheting.

Video tutorial

If you're not feeling confident enough after reading these steps, please follow our video tutorial.