KAVAN Der mini Falke 710mm - Instruction manual

Introduction

The hand launch glider (HLG) Der Mini FALKE (Mini Falcon) has been designed with beginners looking for their very first model in mind. You will need some basic modeller's tools, glues and dopes – you will find these handy with any of your future projects as well. Please make yourself familiar with the building plans and this manual BEFORE you actually start the assembly.

Before you start

Glue: You can use solvent based modeller's glue (UHU® Hart etc.), medium cyano (KAV9952 KAVAN Medium CA etc.) or water-resistant white glue (KAV9960 KAVAN White Glue etc.).

Dope: KAVAN Classic line Protective Dope (KAV9988) and Thinner (KAV9990) are highly recommended.

Tools and accessories: You will need a perfectly flat building board (at least 150×700 mm), builder's triangle, sanding blocks/sponges with 180–200 and 360–400 grit sandpaper, model hobby pins (KAV0355 modeller's pins), soft flat (1/4"–3/8") brush, thin clear plastic film to protect the building plan/building board (a large PE bag cut open will work).

Precautions

The model you build and fly is not a toy! Although it may seem light and slow in flight, it is capable of causing injury or other damage if mistreated. It is up to you whether you build the model properly, fly properly and continue to fly in accordance with common practice and rules (and common sense). If you are just getting started with aircraft models, ask for advice from your model shop or an experienced modeller at your local modelling club to find a good instructor.

Before construction: Build the model exactly as instructed. Do not change or modify the model. If you do, you risk that the model may be unsafe or unable to fly. Take the time to build everything firmly and reliably. Use appropriate tools, accessories and other equipment that is in top condition. Correctly install all parts of the model and check the model before the first and every subsequent flight.

Note: We, as a kit manufacturer, can guarantee you a premium quality kit with detailed instructions, but flight characteristics and performance depend entirely on how you complete the model. Since we have no control over how you complete and operate the model, we cannot (and cannot be assumed) assume any responsibility for any damage caused or related to the operation of your completed model.

Specification

Wingspan	710 mm
Length	505 mm
All-up weight	70 g

Before you start

Glue: You can use solvent based modeller's glue (UHU® Hart etc.), medium cyano (KAV9952 KAVAN Medium CA etc.) or water-resistant white glue (KAV9960 KAVAN White Glue etc.).

Dope: KAVAN Classic line Protective Dope (KAV9988) and Thinner (KAV9990) are highly recommended.

Tools and accessories: You will need a perfectly flat building board (at least 150×700 mm), builder’s triangle, sanding blocks/sponges with 180–200 and 360–400 grit sandpaper, model hobby pins (KAV0355 modeller's pins), soft flat (1/4"–3/8") brush, thin clear plastic film to protect the building plan/building board (a large PE bag cut open will work).