KAVAN Smart PRO SE6 6ch BUS servo decoder - Instruction manual: Difference between revisions
Mrs. Kavan (talk | contribs) |
Mrs. Kavan (talk | contribs) |
||
| Line 67: | Line 67: | ||
|No | |No | ||
|} | |} | ||
=== Installation === | |||
Attach the required servos to the SE4 servo expander. Connect the receiver – use its output port with the serial data option. The SE4 uses the MR30 connector for primary data input. | |||
Turn on the transmitter and apply the appropriate power source to the receiver. The status LED starts blinking as soon as the SE4 detects the signal on the serial line. | |||
Revision as of 14:16, 16 October 2024
Introduction
Congratulations on purchasing the KAVAN Smart PRO SE6 4ch BUS servo decoder, a device that converts serial bus signals to standard PWM servo outputs. It offers up to six configurable servo outputs with optional period and fail-safe settings. The SE6 is a perfect choice for models with complex wing or tail mechanics where multiple servos may be connected to a primary receiver using just a single cable. In addition, if you are running out of receiver channels simply connect the SE6 to the receiver serial line and freely assign its own output channels.
Supported protocols:
- Futaba: S.Bus/S.Bus2
- Graupner: SUMD, Hott telemetry for setting
- JETI: EX Bus
- Multiplex: SRXL 12ch, SRXL 16ch
- PowerBox: P²Bus
Features
- Small dimensions and high current throughput via the integrated MR30 power connector
- Automatic detection of serial data/telemetry after startup
- Configuration through the transmitter, external terminal (JETIBOX/SMART-BOX) or MAV Manager PC software
- Firmware updates via USB interface
Technical specifications
| SE4 | SE6 | |
|---|---|---|
| Dimensions (including connectors) | 34×14×9 mm | 34×19×8 mm |
| Weight (including connectors) | 4 g | 4,5 g |
| Servo output channels | 3 or 4 | 5 or 6 |
| Operating current | 15 mA | 15 mA |
| Operating temperature | (-20)–85 °C | (-20)–85 °C |
| Supply voltage | 4–14 V (recommended 5–8.4 V) | 4–14 V (recommended 5–8.4 V) |
| Continuous current | 15 A | 15 A |
| Peak current | 60 A (2 s) | 60 A (2 s) |
| Supported protocols | JETI Duplex, Multiplex, Graupner Hott, Futaba S.Bus, PowerBox P²Bus | |
| Status LED | Yes | Yes |
| Sensor expander | EX Bus: up to 4 sensors | No |
Installation
Attach the required servos to the SE4 servo expander. Connect the receiver – use its output port with the serial data option. The SE4 uses the MR30 connector for primary data input.
Turn on the transmitter and apply the appropriate power source to the receiver. The status LED starts blinking as soon as the SE4 detects the signal on the serial line.