KAVAN Smart PRO USB-C interface - Instruction manual
Introduction
Congratulations on purchasing the KAVAN Smart PRO USB-C interface used to connect your USB-equipped Smart PRO devices to your PC. This allows you to save or analyse your data or to update the firmware of your devices.
Features
- Dimensions: 33×12×6 mm
- Weight: 2 g
- USB connector: MINI USB Typ B (USB 2.0)
- Current: 25mA
- Supply voltage: 5V
- Output current: 130mA
- Chip: Silicon Labs CP2102
- Transmission speeds: up to 1Mbps
- Operating temperature: -20–85°C
Installation
Connect the USB interface to your PC/laptop using a USBA to Mini B cable. The software drivers are usually installed automatically by the operating system and the interface appears in the Device Manager as a virtual COM port.
If the drivers are not installed automatically, please follow the link below and install them manually: https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers
Firmware update
Firmware updates for the device are transferred from a PC via the USB interface.
The required programs and files are available at www.mavsense.com.
Install the MAV Manager software and the USB drivers on your computer. Check the system requirements.
- Disconnect all accessories from device.
- Connect the USB interface to your PC, run MAV Manager and select the correct COM Port.
- Connect the device according to the picture below.
- Select the *.BIN file and press the Update button.